I'm in PA and drilled a few holes into a closet for some shelving. The other side of the wall is the garage in between an outlet which is 2 ft away and a light switch which is 2 ft away. I hit a piece of sheet metal and stopped drilling. The sheet metal was bouncy but not soft so then I proceeded to place a plastic screw anchor which pierced the sheet metal. Now I'm not sure what to do..no air comes out of the hole so I'm pretty sure it's not a vent. Any ideas on what I should do now?
[link] [2 comments]
from Home Design, Improvement and Services MA http://ift.tt/1HSKThp
via http://ift.tt/1gXxmwq
No comments:
Post a Comment